Vacuum brick extruder introduction

 Vacuum brick  extruder equipment, no matter you need or not, it's all in Zhengtai machinery factory, still not shake, do not sad don't like. Two-stage vacuum extruder is chengtai machinery factory after many years of research and development, producing a new type of brick machine equipment, the equipment can use brick, rubble, fly ash, construction waste, shale, coal gangue and poor clay material crushing processing, such as ingredients, made of bricks, produce the bricks geometry is good, body is close-grained, standard size, up to the national quality requirements.
  Vacuum brick extruder.
1, vacuum brick machine body selects high quality steel plate welded together, the features of reasonable structure, extrusion pressure, high vacuum degree, strong and durable, strong applicability, low consumption, high efficiency, easy maintenance, etc.
2, vacuum brick machine by double mixing extrusion parts (upper) and extrusion molding (junior), and equipped with air compressor system and vacuum system. Adopts pneumatic clutch to implement remote control.
3 reamer host, vacuum brick machine USES wear-resisting material, make the life more than 4 ~ 7 times of the normal reamer; Lead by scientific arrangement (pitch), with "micro pressure transmission, high pressure extrusion" function, can increase the extrusion pressure and improve the work efficiency; And adopt floating shaft structure, which can eliminate or reduce the spindle caused by the long-term use of bending causes the equipment shook his head, shaking; The device 15 ~ 30% energy saving.
4, vacuum brick machine shaft, gear and other important parts adopt high quality carbon steel and alloy steel guitar by conditioning, or quenching heat treatment process, extend the service life of the equipment.
5, vacuum brick extruder press dial the clay tablets, material level control are equipped with a safety device, the device is not easy to damage the main components in the process of use, and improve the efficiency of the equipment fault maintenance.
6, central vacuum brick extruder machine head is equipped with pressure gauge, according to the pressure of the pressure gauge shows the size, can monitor the quality and quantity of products. Raw materials through two-stage extruding and wetting, curing degree and the extrusion pressure is greatly increased.

Whole brick making process:

1)Material is put into box feeder to make sure continuous feeding.Thereis a reamer near the discharging hole of box feeder.It can crash big block

2)Then material is conveyed to roller crusher and crashed into powdery.

3)After that material is conveyed to double shaft mixer.Add water when mixing the material to make it more even.

4)Material is conveyed to brick vacuum extruder.The machine process the material and squeezes out  mud strip.

5)Strip cutter cut the mud strip into equal length strip and convey them to cut adobe plate

6)Adobe cutter cut the brick strip into green brick adobes.

7)Green bricks pass stoving and sintering processes become red brick.